Hydroquip CS6P52Y-S-3W-4 Spa Control System Bundle Hydroquip 3 Wire

CS6P52Y-S-3W-4 is a 3-wire spa control system using the new SlipStream heater. Includes the in.K450 control panel with overlay and adapter plate.

This flow through system replaces the old style trombone shaped flow through heater systems and is used with a circ pump.

replaces CS6234Y-LF-3W

This control system includes 4x equipment cords, a thermowell and temp sensor as well as the flow switch.

Include a thermowell and temp sensor. Or can re-use existing thermowell.  Includes Flow Switch

Includes 4 equipment cords. 

1x 18/3 cord

1x 14/3 cord

2x 14/2  cords

Additional cords available below but they would not usually be needed as the cable set can connect up to 2x 2-speed pumps, 1x 1-speed pump or blower and 1x accessory with the 18/3 cord.

Can operate 2x 2-speed pumps and 1x blower or 1-speed pump along with a circ pump and ozone.

Includes the 5.5kW slipstream heater with titanium heater element and 30 inch cord.

3-wire system

Dual purpose foot bracket

Flow switch control

3/4 x 1 inch barb adapter

Smart-Freeze protection

installation kit included

3/4 inch plumbing connection

Built-in manual reset hi limit

Includes in.k450 Control panel with Overlay

Includes the in.k450 control panel adapter plate in case a larger hole in the spa shell where the old control panel was, needs to be covered, if not this item can be discarded.

Lead Time on this control system can be up to 2 weeks.

Replaces CS6114Y, 6204Y, 6224Y, 6234Y & 6334Y Systems

Additional cords also available (4 included) or re-use existing cords.

30-0318-96  Universal AMP cord with 3 and 4 pin connectors, 96" long = 18/3, Amp cord with both 3 & 4 Pin Male Plugs for optimal flexibility when installing

30-0324-96  Universal AMP cord with 3 and 4 pin connectors,  96" long = 14/3, Amp cord with both 3 & 4 Pin Male Plugs for optimal flexibility when installing

30-0326-96  Universal Amp cord with 4 pin plug 96 inches long  14/4 cable

30-0016-K   Gecko XM/XE  to AMP adapter cord 120v

33-0016A-K   Gecko XM/XE to AMP adapter cord 240v

Cord adapters for the control box are not needed as equipment cords plug into the outside of the control box, not directly to the circuit board.