2HP Waterway Executive Pump Beachcomber 56FR 230v 2-Speed 3720821

Waterway Executive complete 2HP 56 frame 2-Speed replacement hot tub pump replaces spa pumps with similar specifications including Beachcomber Master Massage.

2 1/2″ Intake – 2″ Discharge
This pump has a larger 2 1/2" suction and standard 2" discharge to match your Beachcomber and Infinity spa pump specs and line up with your existing plumbing connections.
(The outside measurement of the 2 inch discharge is about 3 inches and the outside thread diameter measurement of the larger suction side is about 3.6 inches.

This Executive 56 Frame Spa Pump has an executive wet end designed for 56-Frame motors complete with two double-shielded ball bearings and moisture-resistant grease for quieter operation and longer life.

Executive Pump Specifications

2HP Executive Spa Pump Features:

• Executive wet end designed specifically for 56-frame motors
• 56-frame motor for added strength, cooler operating temperature, and longer motor life
• Large 6-1/2" diameter wet end for higher head pressure
• Larger 2-1/2" intake for improved flow performance and reduced noise
• Thermally protected to extend life expectancy of motor
• Wet end can be rotated for easy installation
• Two double shielded ball bearings with moisture resistant grease for quieter operation and longer life
• Two speed motors have four sets of insulated windings for increased efficiency
• Dimensions: 9.08" x 8.05" x 13.28" (H x W x L)

This pump comes standard with the 2 inch discharge port facing upwards, but the wet end can be rotated in 90 degree increments to line up with your particular plumbing configuraiton if needed.

Comes complete with a new set of pump o-rings. Does not include pump unions which are usually already on the existing plumbing.

Replaces PF-15-2N22C, Master Massage Beachcomber 1.5HP and 2HP pump, Aquastorm pump, Super-Flo pump, Infinity 2HP Spa pump,OEM 3720821-13,3720821 and 56 frame, 230volt spa pumps with similar specifications.  Matched performance with 3 amp low speed and 8 amp high speed operation. The dual speed motors have insulated windings for increased efficiency and large, highly versatile 6-1/2" diameter wet end for higher head pressure. A split capacitor (start and run) allows for less energy consumption.

Pump Cord?
Need a mini JJ pump plug and cord or 4 pin AMP plug? We've got those too.  Many times the existing pump cord can be used, so then you don't need a separate pump cord.
If you do need a cord with plug, we offer all the various cord/plug options.