null Your SEO optimized title
Hot Tub Plumbing Tip Heat the Pipe

Hot Tub Plumbing Tip Heat the Pipe

Hot Tub Plumbing Tip for Stubborn PVC pipe or flex hose:

Here's a simple trick that can make the job considerably easier: A little gentle heat!

Using a hair dryer or a heat gun on its lowest setting can help make older flexible tubing more pliable, allowing you to work it over an internal connector or repair fitting with less effort.

Here's how to do it:

1. Start with gentle heat.
A hair dryer is a good choice because it provides relatively mild, controlled heat. If using a heat gun, always start on the lowest setting.

2. Keep the heat moving.
Move the heat source around the tubing rather than concentrating on one spot. The goal is to warm the tubing evenly, not overheat it.

3. Warm a few inches back from the fitting.
When installing an internal connector, warming several inches of tubing can make it easier to flex and position without putting excessive stress on one small section.

4. Work the tubing while it's warm.
Once the tubing becomes more pliable, carefully work it over the connector. You may be surprised how much easier an otherwise stubborn piece of tubing can be to handle!

5. Allow it to cool before testing.
Once the tubing is properly positioned and secured, allow it to cool and return to its normal firmness before testing the repair.

⚠️ IMPORTANT: DON'T OVERHEAT!

This is definitely a case where more is NOT better!

Too much heat can soften tubing excessively, potentially causing deformation, kinking, or permanent damage.

If you notice discoloration, bubbling, deformation, scorching, or smell burning plastic, stop heating immediately.

The trick is gentle, controlled heat. A little patience can save you a lot of frustration!

Get hot tub plumbing PVC parts right here at Hot Tub Outpost.

15th Nov 2026 gen

Recent Posts